Used to apply Quickprime Plus to rubber membrane. It applies the primer at the same time as it cleans the membrane.

Handles sold separately. Please see the related items.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

Quickprime Plus is designed to clean and prime the EPDM membrane prior to the application of Quickseam products. 

Quickprime Plus must be applied with a Quickscrubber Pad and Handle. Please see the related items.

For calculating the coverage of this product, please see the instruction sheet attached.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!
 

The strip is designed to flash inside and outside corners, pipes, penetrations, drain outlets and any other awkward details.

RubberCover QuickSeam FormFlash consists of a 9" uncured FormFlash factory laminated to QuickSeam Tape. 

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

The RubberCover edge trim is designed with its own water-check kerb to be used around the perimeter of a flat roof to direct water towards the gutter edge.

Used to finish the roof's edge where water does not drain into a gutter. This trim acts as a barrier to water at the edge of the roof. 

Permaroof Bond & Seal or Permaroof Closed Cell Foam Tape must be used to form a seal between the trim and the EPDM.

Polypins are used to fix the trim into the Fascia Board. Please see the related items below.

Please note: Image is for illustration purposes only.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

The FormFlash layer is factory laminated to QuickSeam Tape. 

RubberCover QuickSeam Corner Flashing is a self-curing round rubber piece with a diameter of 216mm, adaptable to irregular shapes and designed to flash system details (inside and outside corners, reinforcement patches) in accordance with Firestone specifications.

It is designed to flash outside corners or to be used as a cover patch for repairs where appropriate.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!

 

Quickseam pipe flashings are specifically designed to be used in roofing applications for flashing of round penetrations. 

Quickseam Pipe Flashings will fit various penetrations and must be cut to the correct pipe diameter before installation. 

This flashing can be used on pipes up to 6 inches wide.

Quickseam Pipe Flashings may be used to flash penetrations for both EPDM as well as APP and SBS Modified Bitumen systems.

If you would like any more information on this product, please call the number at the top of this page and speak to our super efficient sales team now!